Separate names with a comma.
Hi guys, 1. Full exhaust inc. header and pipe with the exup mechanism (all parts in a cardboard box), also have the cables. Doesn't come with...
I have two full FZR250 engines for sale/wreck, one is a 3LN3 with a suspected busted B/E bearing and the other is a 2KR non EXUP engine with a a...
I've got a Yamaha FZR250 for sale. The bike runs perfect but isn't registered. All it needs is rego, the bike is roadworthy and ridable! I lost...
Hey guys, I'm after the following parts all for a 3LN5 (Single headlight model). Tail Light Rear Centre Fairing Rear Right Fairing...
Hey guys, I'm located in Liverpool, NSW. I have for sale a 3LN5 engine with a busted big end bearing! The engine will start and run but...
Hey guys! I'm selling a Yamaha FZR250 1992 (Single headlight) model bike. It is registered until the 7th of May. The bike just had a 2KR non...
Hey guys, recently I did the valve clearances on my FZR, when putting everything back together I couldn't exactly get the notches lined up...
Hey guys, just need some vacuum gauges for a day so I can balance the carbs on my FZR, it's a 3LN7. I'm located in Sydney, the Liverpool area...
I just checked my valve clearances and removed the shims, my question is, should I just follow the FZR400 manual for the new shim sizes (roughly...
My bikes is running very rich, a tank lasts about 120KM. The needles were set to the richest setting, however moving them one notch down makes it...
Cleaning the carbs hasn't fixed ****. It's running rich as a motherfucker and the idle fuel mixture screws don't do anything, be it 1.5 turns...
When I first got the bike it was running a bit rich, nothing too bad as it was better for it to run rich than lean. It also had descent fuel...
Hey guys, I'm after a 3LN3 (Single headling model) windscreen, preferably in dark black tint. I bought one last week but had an accident on...
Last night I was riding home and my bike started to stutter, basically had to idle at 8K RPM at the lights so it wouldn't die in the ass, I...
Occasionally when I put my bike into 2nd from 1st it stays in there but then pops out into neutral. This happens even if I don't use the clutch....
Are stopples bad for the bike, some people here say that it's one of the few stunts that doesn't actually screw the bike over that much, is this...
So I park my bike on the kerb (Weird slope) and I get off, turn around start talking to some lady, turn back and see my baby falling followed by a...
I'm sorry if this has been asked before but is the Exup valve realy that important, I mean is it really as good as people say it is. If I...
