O Rings?

Discussion in 'FZR250.com - Archives' started by FZR250Guy, Dec 16, 2006.

  1. FZR250Guy

    FZR250Guy New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Nov 8, 2006
    Cleaning the carbs hasn't fixed ****.

    It's running rich as a motherfucker and the idle fuel mixture screws don't do anything, be it 1.5 turns or 3.

    I don't know what to do, a mechanic told me that it could be the O rings, any ideas?

    I got a replacement bike for now so I can do anything to it. not in any particular rush.
     
  2. _M_

    _M_ New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Mar 1, 2006
    It could be the o-rings, but id bet on the floats being fubar, just because thats what was wrong with mine after i had the carbs balanced etc. , if its running smooth and rich then thats what id say it is.

    i may be completely wrong but anyway.

    my 2c.
     
  3. FZR250Guy

    FZR250Guy New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Nov 8, 2006
    Yeah, it's running smooth and extremely rich, tends to flood at low revs when being started and goes down then up when you twist the throttle and let it settle.
     
  4. HptK

    HptK New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Aug 30, 2006
    its running rich then! clean the air filter too. my bet would be on the floats. if they are only a little bit out on these bikes, they run like shite. get you needles and seats checked. my bet is they are fubar.
     

Share This Page