Separate names with a comma.
motor is 87 i believe( i bought and put it in myself) but its defiantly an HX1 with 2KR frame with No EXUP, its registered as an 88, unsure why if...
Thanks Dave, does this chart apply to 2kr models with no EXUP? That chart seems in-line with what i'm getting on road.
Hi, I'm a long time Fizzer owner. I've got myself a shiny bright orange 1988 FZR250 2kr model. I've had it for a few years now, i've replaced the...
Thanks for the replies. What is the part labeled 32 on the diagram, does it play apart in vacuum? Is it only attached to the 3rd/4th carb...
As the title says, when I rev it and put my hand over the intake theres a good amount of sucking going on, but when its at idle theres very little...
Hi there, I've switched engines with another 2KR engine from another year. It has a more square bottom oil sump than the older one. My problem is...
I take the tensioner completely off before taking the cams off, and replacing the tensioner after the cams are tightened down, yes i push the...
please reply someone, i need this bike up and running soon as possible
heres a picture of it to get a better idea http://www.flickr.com/photos/91266500@N02/8286242117/in/photostream...
I've taken the cams off and reset them a few times. I'm having trouble getting both cams to line up with the dots on the guides. right now the...
I'm re-setting the timing and checking it again, is it possible to be at TDC at the flywheel and cylinder one is not TDC. I did a valve adjustment...
I've just tried spraying CRC directly into the intakes with out the carbs on while kicking it over and i get firing on each cylinder. So take it...
Well... Just tried other set of carbies i can't get it to fire up at all with that set. And I just changed and cleaned the spark plugs also and...
Re: No power after reconnecting uh oh I've got a new problem, the bike only starts while holding throttle half open and kept there and it won't...
Re: No power after reconnecting uh oh I've seen what I've done. The terminals on the starter solenoid were touching when i connected the battery....
Hi guys, I've recently replaced my engine with another 1HX motor, I had the replacement engine compression tested and the starter motor was...
Can someone help me out theres an 3LN motor with guages going for $250, I just want to know what other parts I need or is it as simple as taking...
Hi I'm new to these bikes i'm wanting to know whats required basicly to swap an 2KR engine with a 3LN one. cheers
Carb and head gasket.. great. Can the head gasket be replaced while the motor is in the frame? can someone with basic knowledge and tools do the...
I bought a 1987 fzr250 2KR model a few weeks ago because my car dropped its oil.. but this bike has been giving me alot of problems but i love the...
