Separate names with a comma.
Hey guys finally got the bike running and took it for a ride. Found the steering bearings to be loose just wondering how I go about adjusting these??
Alright thanks guys!
Is that in mm? Ahh that would make sense thank you! :)
Worded that wrong I mean that with it running if I hold my had above the carb I can feel a bit of back pressure. Do you know what the specs for...
Hey guys, Need some info in relation to valve clerances on the ZXR250's. just had the carbs reco'd but still has a bit of feed back through the...
Sorry bud, should have said needle seat in the carb :)
Whos had the seats out and how do they come out?
Seal kit and new needle and seats it is! Thanks guys. I will keep you posted on how it goes.
Its looking like it could be overfueling, pulled the carb out and bowls off checked the floats and it dumping fuel in when the needles are...
Does any one have a vac line diagram?
I will have a look for vac leaks tomorrow. If not i will order a kit. Doez it include needle amd seat, and jets?
Hmm i did clean them but thats a possiblity the carb was full of gunk. Would it be worth rebuilding the carb?
Just adjusted the basics, mixture screw 2 and a half turns out, float level checked and ok. Just cant figure it out.
Yes, one of the first things i tried.
Hi guys! , just bought a 1991 zxr250 but cant get it to idle. So far i have replaced the carb with a second hand also cleaned and adjusted that...
