Separate names with a comma.
sorry it took so long im not uploading the pics of the conrod oilway's and matching crank oilways [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
sure will but will be in a cple of days as having flooring fitted and everythings all over the shop atm
heres a few of what i think your after [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
i'll take some photos in the morning for you as my spare one is out the cases atm
the subframe was nos came with my spares purchase last year , the small brackets front bracket are out of my spares bike just back from powder...
well looks like im gonna be busy before the new job starts nice bit of shiny shiny to sort out [IMG] [IMG] [IMG] and a bargain off the fleabay...
heres the solution to the reservoir bracket using a stainless connector nut and some epoxy metal molded[IMG] [IMG]
and heres the rear caliper and m-c all fresh in 3 coats of acrylic enamel and 2 coats of lacquer with new piston seals ready for new pads [IMG]
[IMG] [IMG] [IMG]
ok so just bolted up the yzf750r master cylinder to the clipon two things i found the m/c first hose from the splitter wont reach so will get one...
thanks chaps
hey everyone has anyone got the dimensions of the front fender (mudguard ) brace/bracket across the holes center to center both across the...
Back after a long break due to illness now I need motivating have been in two minds whether to do a rolling resto or full strip down over a year...
Got a set of grab it bits today will let you know if there any good soon as I use them they just look like reverse ream CNC bits Nice clean discs...
If you use easyouts on that make sure you use the smallest one with the right pilot hole as it will split the bolt and crack the housing done that...
Thanks Blair only reason I was using the code off the carb didn't think to call them 3ln1 / 3ln6/7 Been ringing around seems I will have to get...
OK had to strip down the 3ln00 carbs again because I can't get them to stop flooding and running at 6tho idle and got three of the throttle...
if you think its been on its side the im 100% sure your front end isnt running true also check rear wheel / chain is runnig straight and your...
got them off fleabay for the main jets but there 8mm slot head not the 6mm ones and A-BAX PRECISION ENGINEERING for the pilots
the forks issue sounds like your forks arent running inline theres loads of utube vids showing you how to set them correct basically you stand...