1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

NSW ZXR250C Carby and engine bits

Discussion in 'FOR SALE' started by Linkin, Oct 12, 2018.

  1. Linkin

    Linkin The Apprentice Premium Member Dirty Wheel Club Contributing Member

    Messages:
    3,688
    Likes Received:
    2,162
    Trophy Points:
    943
    Joined:
    Mar 18, 2014
    Location:
    Sydney NSW
    My Bike:
    '99 YZF-R6, '99 GSF250VY
    I have a complete set of jets, holders, needles, pilot mixture screws, new float bowl gaskets, drain screws, needles etc. Basically all the keyster parts I didn't use (choke plungers, diaphragm brass bits, drain screws) and the old jets out of my carbs that are perfectly serviceable. The float needle seats have had their screens removed and they need new o-rings, but they are useable.

    Pilot jets are #35, Mains are #122 and #125, needles are N1QW.


    I also have a complete set of C model valve springs (yet to be measured), about 10-12 valves that are useable, a set of valve buckets, retainers, and collets, plus a bag of mixed shims.
     
  2. TonyZXR

    TonyZXR Active Member Premium Member

    Messages:
    302
    Likes Received:
    166
    Trophy Points:
    148
    Joined:
    Apr 17, 2018
    Gender:
    Male
    Location:
    New South Wales
    My Bike:
    GPX250, ZXR250A, ZXR250C
    Are they 7.9 shims I can`t remember? . I`ll probably take em off your hands if they are
     
  3. Linkin

    Linkin The Apprentice Premium Member Dirty Wheel Club Contributing Member

    Messages:
    3,688
    Likes Received:
    2,162
    Trophy Points:
    943
    Joined:
    Mar 18, 2014
    Location:
    Sydney NSW
    My Bike:
    '99 YZF-R6, '99 GSF250VY
    They will mostly be 7.9's with a few 7.48's in there
     

Share This Page