1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sprocket

Discussion in 'FZR250.com - Archives' started by seifer, Mar 7, 2007.

  1. seifer

    seifer New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Jun 6, 2005
    Hey guys, I just bought a new front sprocket and went to replace it but found them to be slightly different. The sprockets themselves are the same and both slide on fine but the one already on the bike has rubber spacers attached on wither side so it doesnt slide up the shaft. So why does my new one not have this, I cant seem to work out how to swap them over so any ideas?
     
  2. koma

    koma New Member

    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Joined:
    Sep 3, 2004
    Umm... a picture tells a thousand words. <!-- s:wink: --><img src="{SMILIES_PATH}/icon_wink.gif" alt=":wink:" title="Wink" /><!-- s:wink: -->
    The usual procedure is to remove the sprocket cover, undo the sprocket nut, then it should just come right off. Install in reverse procedure and voila!
     

Share This Page