1.Yeah, that's strange.It supposed to turn on @ around 80 deg. C. if I'm not mistaken. 2.If there's no leak just leave it as is.The oil is sealed...
Hi Bizz, I believe we have the same bike- 2KR frame w/o the exup. How much did you buy for the head gasket & cylinder head cover gasket? Good...
Yeah, I thought of adusting the needle but it was a screwed- in on the throttle slider & there wasn't notch on it. Perhaps it came just like that...
Hi! What do the pilot screws regulate? Is it airflow? Fuel ? Or mixture of the two. I’m confused. My plugs are always fouled w/ gas. I suspect...
Yes, the spacer is naturally domed & is inserted w/ the convex part topmost. Don't seemed they were flat as the 2 spacers were domed perfectly....
Some of the screws that hold the float & diaphragm cover are hard to remove as they are being seized. Spray w/ WD40 & use impact Philip...
Then you can furnish me the stock size for the jets (main jet, pilot jet etc.)pls.! Some of the jets were broken when triyng to unscrew them.They...
I agree w/you. I had a hard time separating those 2 tubes and the edges of the bushes have been chipped a little. Well I thought if i have to...
Hello Guys, Perhaps you would like to check this one. A $4 carb. synchronizer. Read about it & tell me what u...
So far you're doing good, mate. The 2 bushings are made of steel that's why you hear a solid banging sound. Better if u have a soft-jawed vice,...
Be patient. You might do several snapping force to separate the 2 tubes.Like I said its the 2 bushings that causing this. The slide bushing is a...
The tube can be separated now. Use much force as the the slide bushing of the upper tube is banging its way pass the guide bushing of the lower...
fork oil seal size is 35mm x 48mm x11mm. Tips: loosen the hex bolt under the outer tube before removing the top tube cap., othrwise you have to...
Thanks for the replies guys! I have cleaned the carb. but didn't do balancing. Noticed 1st slider is not moving when revving. My s. plugs are new...
Hi, Pls. tell me what are the causes of gas-fouled s. plugs? I'm experiencing this on my Fzr and it would start when I blow it dry. Thanks.
Found the fuse behind the battery just what Ace said. It is broken.Don't know if it is the main fuse though. Mine is 2KR. Hope is not that...
Hello everybody! I have switched the polarity when I was jumpstarting my bike w/ my car's battery. Now no light when I turn on the ignition....
Separate names with a comma.
