Separate names with a comma.
Well, I sent my bike into the mechanics for a major service on Tuesday. $750 later it came back good as new! Had the carbs stripped and cleaned,...
Was wondering if there was a place I could get a whole new set of fairings from. New. Is there anyone who makes fibreglass sets? thanks
Date: Sunday 25 September 2005 Time:8:30am BP The Gap - Leave by 9am Route:Up Nebo Down Glorious to the "T". To fernvale for a bite to eat and...
Read here: <!-- m --><a class="postlink" href="http://forum.twofifty.cc/viewtopic.php?t=44">http://forum.twofifty.cc/viewtopic.php?t=44</a><!-- m...
I have 110/70 on the front and 130/70 on the rear. What do you have? Do you recommend going to an 80 profile? Will this give better handling and...
Just bought an FZR, the temperature gague doesn't work. I think it goes up to the "warm up" mark but no more. Any ideas what this is and how it...
My rear suspension is bottoming out. I need a new spring, any ideas where to get one in Brisbane? Is it easy to replace?
Lately my back brake has felt like it hasn't been working until right at the end of the lever. I usually fix it by giving the break a few good...
My rear sproket, rim, swing arm, spring etc are pretty oily/sandy/grotty... Can I just chuck a shitload of degreaser on it and hose it off? Then...
Came across this while looking for info on EXUP. <!-- m --><a class="postlink" href="http://db9xq.de/exup.php">http://db9xq.de/exup.php</a><!-- m -->
May need a new EXUP Servo Motor soon. Does anyone have one lying around? I've got a 1990 [3LN II] FZR250. PM me or post below if you can help....
I've taken the left fairing off, taken off the cover and cleaned the cogs, wd40'ed them and put it back on. The alignment confuses me though. Can...
I had a bit of a tick noise at low revs when going uphill, though it may only be because i can't hear it at high revs... it's a low pitched...
The screen on my 250 was yellow, faded & ugly. A mate suggested using brasso to clean it up. I gave it a go tonight... It's clear now! I'm very...
1. My headlights are being dodgy at the moment. When high beams aren't on the bottom two little globes should be on, and the halogens should also...
My bike used to run a bit rich, now after the mechanic screwed around with it ( did a good job though ) it's running too lean for my liking. How...
Since a few days ago I realised my left headlight was permanently on high beams. Any idea how to get rid of this?
Just wondering do I need to take the fuel tank off? Why did they make it so hard to do this? Also, if you take your RHS rear fairing off next to...
I want to respray the bike. I was thinking a deep purple with glitter for something original. I was thinking of respraying the wheels too and...
I need some oggy knobs, just incase. I figure it's a wise investment. Does anyone know where i can get them from and where to fit them? I'm...