/ Register

  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Help FZR250 Transmission bearing and other questions

Discussion in 'Yamaha 250cc In-Line 4's' started by ruckusman, Sep 23, 2019.

Page 3 of 3
  1. ruckusman

    ruckusman White Mans Magic Master Premium Member Dirty Wheel Club

    Messages:
    3,230
    Likes Received:
    1,416
    Trophy Points:
    918
    Joined:
    Oct 1, 2013
    Gender:
    Male
    Location:
    Narrabeen, NSW Australia
    My Bike:
    Yamaha FZR250 3LN1
    This one may be a good candidate, centreless grind down the outer diameter and cut the NR ring in the appropriate location for the extra race width and use a thinner oil seal to compensate the extra width if available - it's not cheap though but should be well and truly up to the task

    https://au.rs-online.com/web/p/ball-bearings/1959540/
     
    ruckusman, Feb 2, 2020
    #41
  2. maelstrom

    maelstrom LiteTek Staff Member Premium Member 250cc Vendor Contributing Member

    Messages:
    5,107
    Likes Received:
    3,473
    Trophy Points:
    1,148
    Joined:
    Dec 23, 2012
    Gender:
    Male
    Location:
    Thailand
    Home Page:
    My Bike:
    Yamaha FZR400 3TJ1, Honda MC22
    The ID, OD & width all need to be modified. A double row ball is fine. There is no significant axial load to justify angular contact. I am sending the OEM bearing as a sample and all going well will have them in about 6 weeks.
     
    • Like Like x 1
    • Agree Agree x 1
    maelstrom, Feb 2, 2020
    #42
  3. my67xr

    my67xr Bike Enthusiast Staff Member Premium Member Contributing Member

    Messages:
    4,313
    Likes Received:
    2,383
    Trophy Points:
    898
    Joined:
    Jun 18, 2016
    Gender:
    Male
    Occupation:
    Panel Beater, Spray Painter, Custom Fabricator
    Location:
    Adelaide, South Australia
    My Bike:
    Yamaha's , 1990 FZR250R 3LN3 , 1986 XT250TS 57R , 1984 IT200L 43G, 1976 IT400C 510
    my67xr, Apr 4, 2020
    #43
  4. ruckusman

    ruckusman White Mans Magic Master Premium Member Dirty Wheel Club

    Messages:
    3,230
    Likes Received:
    1,416
    Trophy Points:
    918
    Joined:
    Oct 1, 2013
    Gender:
    Male
    Location:
    Narrabeen, NSW Australia
    My Bike:
    Yamaha FZR250 3LN1
    Interesting listing, when I saw the email come in I was all excited, until I saw the dimensions of the bearing

    The actual bearing required is 22x50x20.6 for the sprocket end, which thanks to @maelstrom we know for sure as he's managed to get one off of the shaft

    However now that I think about it, it may be for the other/clutch side end, but that one is supposed to have a locating ring

    I'll check tomorrow, but I already have the other three bearings
     
    • Like Like x 1
    • Agree Agree x 1
    ruckusman, Apr 4, 2020
    #44
Page 3 of 3

Share This Page