Ok so these are up for grabs. I will take a couple of photos later to add to the thread. They are good condition, everything is there except the diaphragms as I used those to repair other carbies. They will need a soak probably in ultrasonic as there is yellowish staining in the bowls and maybe a good clean out with compressed air etc. A seal kit and a clean up should see them quite usable. I was intending to rebuild them fully but I honestly can't be bothered now. I have all the original components (slides, needles, emulsion, floats, float valves, jets, pilots etc) and these will come with them. Alternatively, if you want new keyster components I can supply most of the above listed items new for extra cost (can negotiate depending on what you want new). $115 posted anywhere in Australia for the original set minus the diaphragms and some of the original seals which have just disintegrated and disappeared. Probably better to get a Litetek kit anyway.
Sorry my mistake they are 3ln 6/7 carbies not 3ln3/5 and have the better needle setup. Havent had a chance to dig them out for new photos but there may still be photos in the second fizzer thread as they came with my black parts bike.
Photos. They're in good condition, could not find any cracks/leaking points etc but are obviously used. They are a bit dirty as they've been sitting out in my shed for about 18 months (whoops). @ruckusman @maelstrom This is the contents of one of the baggies full of internal parts, you can see the needle setup is the desirable 3LN6/7 setup. I didn't bother emptying the other baggies but I'd be safe in guaranteeing 99% of the original components are there (might have dropped an old seal or two, for example).