Separate names with a comma.
Are there any inhouse specialists who have worked on the cam chain adjuster on the KLH. P 70 of the manual says to reinstall the tensioner body (...
Tks for that 250 Resources has a workshop manual for the X and the clearances are the same as earlier ones. At 10k kms the exhausts are all at 8...
Murdo, is this the clip that you're talking about? So you mean -squeeze the little green tabs together
[ATTACH]
Confession time. I am a dork. Bought this bike with 6300kms on it. Now 10000 so I thought that it was time to check the clearances and if good...
THANK YOU. I went into RESOURCES but didn't go far enough earlier to find this. Wonderful. Now all I need to know is how to release that Quick...
Yes, it's not a 250 but I'm on a site where there's a lot of expertise so some one may have a link to a manual. I've read Ruckusman's thread but I...
Yes, with the BMW K100 you can change sims in situ, using a bucket depresser tool but that's because the shims sit on TOP of the buckets. With the...
I can do the shim change for exhaust if it's a must do - just a PIA if you are used to screw and locknut and will get someone to check when i'm...
When the bike wouldn't start (20k kms) I thought I'd better check the valve clearances (4 valve head) R exhaust 4 thou (.10mm) shd be...
Well, that went well. I got a call from the inspection guy who said that there was an email for me to show the local RMS (RTA) stating that it was...
Andy quote: "As you can see, the front brake line says 4/91, the master cylinder only has Nissin on it but the cover is all in English and my...
Andy, the RTA guy has been to look at the bike and went over it looking for evidence of its being MADE in 1990. The brake lines have been replaced...
So i learnt that the RatBiKE (tHEtREVS) carbs were very good. I'll leave them the good red Spada. I will dismantle Robs carbs and try new jets...
so is yours the same i.e. speedo, brake reservoir caps, warning light? is it likely that they just sat until 1991
I bought this spada from tHEtREV in brisbane a year ago and it was a bit rough but went like stink. [ATTACH]...
Tks [ATTACH]
I did and it just looks like it's all parts !!!!!!!!!! I have been talking to a guy at the RMS who has been very helpful and said that if i sent...
where was that on the Impex site?
OK, I stuffed up. I was looking at the 11th VIN digit and it is "M". The 10th digit is "L" so that is 1990. Adych - your bike is a 1990 model...