Separate names with a comma.
Hello everyone, just starting this thread as a log of my repairs of my Honda. I'll add more as parts come in.
If you don't know its service history then it would a good idea to pull the top triple clamp and inspecting the bearings, its most likely the...
Well, finally got around to doing some further diag on the bike. Found the rear cylinder carb diaphragm wasn't installed properly so the slide...
Ah i see what you mean, i have replaced my fuel vacuum line with silicone hose so shouldn't be too bad. I coated the tank with a coating and run...
When you say carb vacuum hose, what do you mean?
Starts with a tap of the button, idle is rock solid and all the way to 8k rpm its good but above there not much happens.
Pretty much "here's the kit and youll have to figure it out" i suppose id get more support if I bought the product but throwing $2000 US at a bike...
A little back and forth from the Ecotron people and I got quoted $2000 US for a kit. Faaaaaaaaaaaaaaaaark.
I was thinking about it, why not throw more money into a 250cc :D
It seems that all of his struggles are with mix and matching components to work together with an open source ecu. the Ecotron looks like a kit...
Anyone considered doing this upgrade? Doing some rough calculations that a 55mm throttle body would flow a bit more than the factory 32mm carbs...
Would you do a hose kit for a Honda VT250F?
I'd check that you're getting spark to the right cylinders, sounds like you've got the compression and fuel to get things running.
Hello everyone, trying to find a new shock absorber for my bike, its the only thing holding up from being roadworthy. Is there a more common...
Cut it out and get some air filter foam and make up something similar.
In my case it involved cutting all the paper filter material out and then packing that area with foam. I'll try to find a pic of another member...
I couldn't find any through my usual sources unfortunately. But as i found with my 1983 VT250FD i had to make my own filter, using some filter...
Well good news, replaced the seal and the push rod and I'm leak free!
thank you for the reply, do you know what purpose the cavity on the rod is?
Hello, I've got a 1983 VT250FD which is leaking oil from the push rod seal. I've replaced the seal and it still leaking from the centre of the...