Separate names with a comma.
Tube is 100mm with 3mm wall. plate is 9.7mm. Gussets are 6mm. I have to wind up the current on my welder for this. The torch gets bloody hot after...
this is what my welding work looks like these days. still not super pretty, but more than adequate. [ATTACH]
Never used anything other than 2.4 tungstens as that is what my torch is set up for. Mostly use white but have used red when in a rush and too...
TIG welding Aluminium is an acquired skill. Satisfying when you do a good weld though. I am certainly a long way from an expert. The main trick is...
A typical economical multimeter (like this one https://www.jaycar.com.au/economy-catiii-multimeter-with-non-contact-voltage-sensor/p/QM1527 )...
Haha. Not an unusual issue. Try some stainless steel wool to clean up the terminals on your coils and meter probes. make sure the wires between...
Also, make sure all the connection points are clean.
Start by connecting together your leads from your meter and taking a measurement. This will most likely be a value greater than zero (0.0 ohm)....
Sorry guys. A lapse of concentration. Lower resistance means HIGHER current. But, of course, the TCI needs to be up to the job. Interestingly the...
Hi Frank, Are these coils actually original ones. Are you sure they are not from another model. A lower coil resistance will theoretically result...
Is there a highlights version? I haven't got 10 hours to sit and watch.
a potential good pick up for someone. But I have no room. Peter.
The VJMC is quite sizable, as Frank has already indicated. Membership is north of 2500 Australia wide and growing. Focus is on the preservation,...
Wow. I fully appreciate and understand time issue, but hadn't appreciated that, in a real commercial environment, that fuel/energy costs would be...
If you cut back the flywheel and as a consequence cut back the magnets you will reduce the magnet field available to the alternator. this will...
Closing throttle cables are important when running flat slide cards (as opposed to ones with a butterfly valve). The vacuum applied to the slides...
@Frankster as much as I think the EV tax win is a great example of a win for the little folk, there needs to be a mechanism for EV drivers to...
What exactly is the problem. Clutch not disengaging? Send some photos can often help.
Looks to me like someone attempted to pop out some dents by pressurising the tank and just over did it. I would certainly start by trying to...
Take all the plugs out and see if it will turn over on the starter. If still no good, put it on a rear stand, put the bike in gear (ignition off)...