Separate names with a comma.
The keyster needles also felt like the spring was a tad stronger, again another variable Sent from my LG-H815 using Tapatalk
Rechecked the floats, the tip definetly wasn't compressed when I'm measuring, however the float hinge has a bit of play. Anyhow dropped the float...
The pilot screws are at 2 turns out as stated in the manual (I think). Bike ran well before, except for being a bit thirsty for my liking, put...
Needle circlips in the middle position, with the two small shims under the centre 2 carb needles to raise it half a notch. I'm happy with how it...
Just put a keyster kit through the carbs on my 89 3LN1, including new float needles, jets, emulsion tubes, needles. Not sure why but the seemingly...
I was a bit suss when the bloke at the yamaha shop recommended full synth haha. Yeah definitely got plenty of slack in the lever, I'll give it a...
Full synth yammy 15w50, which may also be to blame but just the way it releases so damn late has me thinking its the adjustment.
I can get slack on the cable but the clutch still releases very late and seems to slip on quick gear changes. Apparently (according to other forum...
Hi all, just picked up this 89 model FZR250R 3LN1 I believe. Having a few issues with it, mainly with the clutch adjustment, feel free to give me...
Any one done the clutch adjustment at the clutch on the 3LN 250? Cant for the life of me get the phillips head screw loose. Is there a locknut I...
