Separate names with a comma.
Hopefully that's what's wrong with mine fingers crossed Are they 7.48mm shims? Sent from my iPhone using Tapatalk
Would this also be why it was running so bad? Sent from my iPhone using Tapatalk
[IMG] Not sure if you can read that but they are out by a fair bit. But would this be why it's not starting? Sent from my iPhone using Tapatalk
Thank you so much mate Sent from my iPhone using Tapatalk
I tried what Linkin said and try to start it for a while and cylinder three still had a cold header so will pull the valve cover off and check the...
Cheers Will check tomorrow Sent from my iPhone using Tapatalk
I have even used that aero start in the carbs and still won't turn over Sent from my iPhone using Tapatalk
It ran before without the air filter and fuel pump Sent from my iPhone using Tapatalk
Are there any vacuum hoses that need to be hook up? Yes coils are to the right cylinders Sent from my iPhone using Tapatalk
It's a project ah Yes it's defiantly getting fuel into the carbs No fuel pump Where are the pilot screws located? No, needles and needle jets...
Yeah was thinking that could be a possibility thanks for the tip Sent from my iPhone using Tapatalk
1991 i think 3ln Sent from my iPhone using Tapatalk
Hey just need some advice on what to do. My fzr 250 died on me awhile ago and couldn't seem to get it going again. It has compression, new fuel,...
Thanks for the tip! Sent from my iPhone using Tapatalk
Thanks for all the replies but I fixed the problem put new spark plugs in Sent from my iPhone using Tapatalk
not sure I think so but how could I check?
got fresh fuel.
okay I cant do either of those but I guess I will have to learn! when I try and start it there is little bit of white smoke coming out the exhaust
the choke is fine I pulled it across with my fingers and it slide fine
fuel line is good and carbs are good inside. cleaned bowls and checked the jets and they aren't blocked, made sure the idle screw is the 3 turns out.
