Separate names with a comma.
Hi, I have a 2kr with a 3ln engine in it and the 2kr cdi has completely died, just need a replacement?
http://img543.imageshack.us/i/20122010076.jpg/This is my 2kr with 3ln engine and 3ln rear tail light
Don't need mirrors now brought a brand new pair off ebay for $40
Hi I am after some mirrors and front brake master cylinder for my 2kr, or a rebuild kit for the front master cylinder. I am willing to supply...
Hi I have some parts you may be interested in? I have a clutch lever and the side cover on the engine which hides the started motor sprockets....
Does anybody have a pic of the spacer that goes on the inside of the wheel and rests on the swingarm for the rear wheel? I seem to have misplaced...
Clear screen u can have for $20 pickup is from st marys.
There is no modification needed if you are using a 3ln engine in your 2kr. However if you are using a 3ln frame and a 2kr engine i believe that...
I know it's a long shot but... you know when you have the choke on? and it revs up and then down? just check that the choke plungers are fully...
Hey, Have you considered repairing with some used parts? i'm in the sydney area and have some 2kr engine parts available if you are interested....
I have the Exup cables with the servo and... i dont know what the valves look like as im not familiar with exup. I dont have a fuel pump bracket....
Hey Bob im in NSW Sydney. I have no use for or anything else on the bike apart from the rims,tyres and front forks if they will fit. But the frame...
LOL! @ Bob... had a bit of trouble uploading but i got there. i will upload a pic of my newly painted 2kr frame later....
Thanks heaps for trying to help. I have brought a written off 3ln with a good engine... so they tell me, il have to wait and see once i start it...
Well i wish you luck. They are in a bit of a tight spot especially with one of those push n hold compression testers like i have. you will...
Thanks for replying Trev, I am looking into buying another set of 0.25 rings which will fit my 2kr piston so i will see if i can find some. I have...
hey, i just thought i would throw you a few things to try...a bit of carby cleaner in the tank, check that the choke plunger is not sticking and...
It's all different. The pin seems to be the same when I put the pin through both of them but the bottom and top of the piston are completely...
Never mind i found it! "Kawasaki used a 2mm longer rod in their ZXR750s they raced at one time and Yamaha went to a 2mm longer rod in the 3LN...
Hunt around man! i picked up all the fairing from a 2kr with forks and ignition barrell with the key for $140 from redfern plus i got two rims one...
