Separate names with a comma.
These guys sorted my valve seat / valve cut problem,,(cbr250r) after they (we) sourced a pilot, then ground it to the suitable diameter,,,they...
Before I start removing that horrible white stuff that coats MC19 wheels, did Honda paint, or powder coat them ? Tiny
More framin' thoughts, involving a stiff swing arm pivot , the right "look" & functionality needed :confused: [ATTACH]
It's a good feeling when a plan is still going to plan,,,,:drinks: [ATTACH] [ATTACH] [ATTACH]
White vinegar will get rid of that rust, but, it'll also remove the protective coating on the steel coils as well. 2 days soaking should do it,...
Neway loctite the cutters in place, I discovered that after getting them too hot while diamond dressing them for end clearance :idk:
I usually let the rattle jobs harden up for a month before a wet 2000 grade rub, then T-cut it for an orange peel free mirror finish :thumb_ups:
How many Poofteenths would 0.0001" be ?(cbr250r & rr lingo)
[MEDIA]
A mate is having a fookitt sale soon, his bike collection includes 2 x MC19's (one may be a MC14) I'll update this thread when pics & prices...
MC 19's did NOT use resistor type spark plugs, rather, their plug caps had a resistor in them (removable), running resistor plugs & cap resistors...
Classic non seating carby needle & seat symptoms A'fer
Same stroke, barrel bolt pattern, smaller gudgon pin dia. The advantage would be in having a bare set of cases to machine to suit the ali Barber...
I can help, if you don't mind a 100 cc crankcase set
I checked the barrel , it's a 122cc job, with a bogged up cam chain wear hole,, bore - 56.4 sleeve OD - 61.75 deck height - 68.17 casting # 324 As...
Just ring it's neck, those Honda pistonies melt quickly, then big bore it, & ceramic coat the crowns while you're there :help:
It's on the list of "to do's" Andy. I only have 1 x 125 barrel, I'll make sure its a 124,,,, Go BIG,,go 200,,bore the cases:thumb_ups:
Maybe some things remain the same ?
I might have an XL 125 barrel "in stock" along with a box of used pistons ? Most of my **** is XL/CB 100 (smaller little end eye, although, it is...
I had a norton 650 barrel resleeved & bored at the local Repco shop, in 1970,,they buggered it by boring one pot off center (heaps) I hope you...