Separate names with a comma.
So, 3.8ohms primary resistance gives more current than the upper limit of 2.9ohms recommended for that coil in the Honda manual? They are the...
I have a pair of coils on a Honda VT250F that I think may be ready for the bin. The manual states the following specifications. Primary...
Magnificent work. Well done. Congrats on the championship too.
If you do, then I'm sure Oprah and Harvey can show you around!
This Ginger-Ninja has a YT vid about that dash. I have not watched all of it, so might be a waste of time, but he does go through the setup of the...
[ATTACH]
Hi Dan I'm near Beaconsfield, but I was actually asking more along the lines of helping you swap out the bad engine for a good one and taking the...
Morning Oaks. ZXR250C "C" engine in a ZXR250A "A" frame is a bit like a heart transplant but you need to take the lungs and nervous system too....
Hey Dan, what's actually wrong with your engine and what part of Tassie are you in?
I think I'll go to that. The Maritime Centre is worth a look even without the VJMC event.
I went to the Ballarat Aerodrome today to do a few laps on the bike. The event was a ‘bike only’ show and was sponsored by Geelong Harley...
I'm not sure I'd be proud of a 0.287 reaction time, but there it is. Greg is definitely running much harder with the bike mods; dialed in at 6.95,...
And for those with a sick sense of humour... https://tinyurl.com/35983e3h
Too much fuel. Those jets are huge for a ZXR250C engine. Normal jetting is 122;125:125:122 from Cylinder 1 to 4. You could probably go a bit lower...
I just realised Greg (old mate) raced at WSID recently. I didn't click that it was him as his bike has had a paint job and an extended swingarm...
Hopefully, @Murdo went out today and can give us an update on the Sunday happenings. Otherwise, we'll have to wait for Lamby Shoots to post...