Separate names with a comma.
You are correct that the holes in each header are direct fitment from the factory and are indeed used for setting up the carbs properly. You will...
Those bits are the epoxy used to hold in the magnets on the flywheel - open up the LHS crankcase cover (stator) and you will see the remainder of...
What a run - book me in!!!!!! I've heard two rounds of toast is ample for for an evening meal whilst growing - and at under 5 mins ticks all the...
What a little belter!!!! looking good m8 and considering what you've done to get it there over the last six weeks, fantastic result - a few miles...
Congrats on the bike..will scrub up well :) I have a mechanically similar gsxr 250..several of the guys on here have the same bandit 250 so should...
gorgeous :):):)
Recheck when done for being airtight..carb cleaner into tube and block off one end..watch for bubbles appearing at either joint when firing...
[ATTACH]
No bike replacement needed lol :). Make a template to go around two magnets with a protusion inbetween donating the difference they are apart....
Re epoxy the magnets now before they detach totally and cause $$$$ damage with the engine running..they go when at high revs and it will happen in...
:):):):):):):):) they'll be a day soon when the sun shines, the bikes on full song, lockdown will be ended..can't come soon enough!
Just seen it..looked everywhere on the inbox one and then thought to look here! go easy on that starter..or changing the brushes u'll be next! Not...
Sounds like your making good progress m8..the picture with the four vents blocked off (circled in red) need to be kept sealed/blocked off..they...
will see what I've got up at the unit this weekend fella - is it just the light glass, light glass and light unit, or the light complete with the...
Great work fella!!!!! I'm propper chuffed now its running..steep learning curve being the first four stroke and first four cylinder you ever...
Good luck pal..fingers crossed for yus!!! :):):) get some sleep now..:)
Sounds like your making good progress m8..check and re check everything as you go - valve clearance is 0.17-0.27 in, 0.2-0.3 ex..I always aim for...
Great use of that table m8..and result with that ring!!!! sounds like the valve/valve seat seal is good to go - no leakage is ):):) I like the...
@Andych advice is spot on with regards cleaning, new rings always recommended, but if you go with the originals to keep costs down and they...
Shims are a good sign m8..obviously check and recheck all clearances when you come to reassemble. A good starting point is 16 zip freezer bags and...