Separate names with a comma.
Thanks for the shot, I have now lowered the brake pedal so I can now rest my foot on the pedal without loading up the brake.
Thanks for the link, I decided to modify the clevis for the original footpeg so 3mm at the clevis gives me a couple of cm at the bake pedal and...
Pegs is a little too far out to get right across the brake but feels in a better postion so I don't rest too much weight on the brake.
Now fitted new pegs, need to drill locating hole for spring but now able to get a better position without bending brake lever. [ATTACH]
My little CBR250r MC19 has a footpeg height that is uncomfortable on brake side even fully adjusted it sits to high for easy access to the brake...
Maybe take out the plug and see if it spins with low load. Seems like you have done most things, see if you can get someone to give it a bump...
Looks like Alli have one https://www.aliexpress.com/i/1005005924812382.html
Porn
Not much taller but I have long legs! Maybe the knee replacement is part of the cause, anyone younger than us and didnt have one of these bikes...
Sorry wasnt being rude just trying to work out if my legs are too long! The picture of the VFR800 one allows the height and position to be move...
Short legs??
Thanks Murdo, found another possibility suits VFR800 but may fit up to CBR250r even if I need to mod it a little better than having to start from...
Adjusted the linkage as short as I can, still ankle needs to flex a long way to keep it on the peg and only just touching the pedal. may need to...
Speedo bracket is sandcast as it was done that way in 1930 the mold is fairly simple so doesnt need the complexity of lost PLA with investment...
Anyone found this issue and any solutions, I have adjusted the brake as low as it will go and still find its very uncomfortable as i have to keep...
Yes greensand PLA pattern still trying to get a good mix for greensand using ground kitty litter and river sand but will buy some very fine...
The TPU has been in petrol for 2 weeks and no change in size or feel, you can still see the printer marks. I printed at 100% fill and still...
Here are a few files I made up on 3D printer while setting up carbs, 7mmp1.stl is a 7mm height gauge for floats together a 30 degree setting piece...
Seems like I continue to be plagued with anoying little problems, I fitted new needle and seats to all carbies when I had them striped down the...
Plastigauge then at the shop next week to check the shells accurately again together with the crankshaft it may need a grind to get rid of any...
