Separate names with a comma.
Fill up done, 189kms for 9.63 litres. If I have my calculations correct then that works out to 5.09l/100km. A very significant improvement from...
They were nearly new when I replaced them, not sure how many k's they'd done[ATTACH]
126kms on the odo before orange fuel light came on after first refill since adjusting the carb needle position. This is another improvement over...
Needle adjustment done (see story and pics on my Suzuki Across project post) and fuel consumption has improved I already had 30km on the...
Update: Bike has been going well. Had a concern about running temperature and fuel usage (see post in Suzuki 4 Cylinder forum). Happy enough with...
An update. Refuel at 99km took 6.84 litres. Not sure if I filled tank as much last time (it was night so couldn't see where fuel level in tank was...
Hi all, just finished work on my Across to get it registered. Had the first real ride yesterday and have a couple of questions for any Across...
Bike inspected today. Passed. Rego paid and ready to ride
Happens to us all. Focused on the specifics, a twin disc wheel, and don't think of the other possibilities. Chances are the wheel is used in a...
I would say yes. It is a plastic cover and some Across models had their discs on the RHS.
Just spent end of last week and weekend doing a few tidy up jobs before getting bike inspected for registration. - 2 x dash globes - clean and...
Back on two wheels [ATTACH] [ATTACH]
Back in the bike, seals all done.[ATTACH]
All ready for reassembly. Will do a partial reassembly now, no fork oil in today so the threadlock on bottom bolt/drain plug has overnight to set....
Gotta love the weekend when you can get stuck into a project. Forks dismantled ready for cleaning.[ATTACH] [ATTACH]
Fork Damper Tool made and works a treat. Youtube and a few forum posts gave me design idea and suggested dimensions. For anyone else needing the...
Update: Front tyre has been swapped and wheel balanced. Then it was a wait for the replacement forks to arrive. They turned up yesterday (good...
Success - frame supported with wheel high enough. Wheel out ready for tyre change. Just need new forks to arrive. I will leave old forks in place...
As, the chef's say - here is one I prepared earlier. I made it a few months ago to lift the engine for my ZR-7 project. Didn't think it was tall...
I was obviously so proud of my efforts that my subconscious loaded the photo twice
