Separate names with a comma.
Couldn't love piglet one teeny bit more at the mo. 6l/100 in normal hills mode (same as a schmick LN3 I had) ie as naughty as it is nasty. Plug...
If in doubt, do nothing. Reading is OK tho' www.calsci.com/motorcycleinfo/Airboxes.html
Higher Zeal cams/more overlap and headers meant I had to go 96 on main jets, and fattest needles I could find. The big improvements (getting 6-7...
Sorted. Compared to baseline & schmick LN3 I'm coming off the top'o'climb 15% faster (long steep outa town, no cops) and just measured 3.3l/100km...
Advise everyone to do your best to prolong life of rose bearing 93399-99919 at base of rear shock. Yam can supply from Japan for $AUD114 or...
Defeat admitted. Downsizing jets to get consumption same as EXUP, end up with same power. GF needs a bike, so it goes back to std. PS anyone know...
Shoulda mentioned that both are LN6 carbs with full Viton. So LN6/Zeal cams in an LN3 are a beautiful thing due to smooth torque earlier. But I...
After testing header temp flatstick uphill and then at bottom using IR thermo, tweaked heights. Redid measurements: my std LN3 has sandy plugs at...
I had one with a rattly top end - whacked in a Chinese chain (with trepidation, as it had 1 less link laterally). Same. I had split the cases to...
More importantly, most likely failures are ends of copper wire into caps screw and the 10kOhm resistor within the cap - the majority of mine on 3...
My worked bike was giving me the Shi'ites with wear. Switched from a decent RK chain with regular wash/soak in oil to cheap O-ring 428 with Maxima...
Spec is 140psi+ I don't get half that, but I'm on Zeal cams. Zero leakdown with 130psi applied (rings 0.2mm and oil 0.25, cyl honed) and valves...
Was always a bit confused as to how light a kiss of float tang with spring spigot, guess mine were deep and intense coz... I'm getting better...
I wasted my time at school on subjects like sheetmetal, not chem (but not to a std of making a gal tank). Would zinc anode be better/dumber?
All your ideas have been taken on board. I'm just gonna ride awhile. It's running beautifully. The new stem seals solved smoke blow on startup,...
That'd be 7thou or .3mm my crosshatch was still evident. Chinese topring was still .2 after a lot of hard riding, so I'll put the tightest 2nd...
Eng had 150psi on 3cyls, 60 on another. So took barrels off while doing stem seals to check alignment of gaps, now 60 on all four! Leakdown shows...
There's a concave washer between bushing and seal - anyone know which way up?
Ta. I'm prepared to admit to being delusional, but content at the mo'. Living in the hills, the throttle is always opening up or closing, so...
With my std LN3 as a comfortably sedate baseline, I remain hooked on the upgraded stablemate. Live in the hills, and nimble handling leaves me up...