Separate names with a comma.
Hi everyone, Im in need of a set of Mikuni BSR30 carburettors. Preferably off an xjr400 Any help will be much appreciated.
Hi guys - about to remove my head off the XJR400R - No.2 exhaust valve(one of) is being held open, hopefully just by carbon - so I’m removing the...
Thanks for the quick response. So I have 5k ohm resistor caps which all read within 10%. I’ll put those on and see what happens. Is the resistor...
Also can anyone help me ensure I’ve got my coils and leads the right way round - I suspect they should be the same as FZRs - reason I ask is I’ve...
So I was going through valve clearances this afternoon and no.2 exhaust valve(1of) was being held way open. After rotating the crank a while...
The coils and leads I have don’t have resistors in the caps at all - they’re just straight connectors. [ATTACH]
So turns out I have 0 compression on cylinder no.2 - so will be doing valve clearances tomorrow and see I go from there.
Wondering if 98 octane fuel on my xjr400 is suitable. Any thoughts
Exhaust is clear yes, air filter element looks clear and new. I’ve since found out of the 4 coils I have only 1 is within spec. Also the CDI unit...
[ATTACH] G’day everyone - I’ve been mia for a year or so as I sold my fzr250s. For a grand profit here in nz I might add, they’re sort after in...
@GreyImport hi again - it’s been a while, thanks for the information on testing coils. Do you know a lot about cdi units? I have a 1995 XJR400R...
@gregt @ruckusman thanks for the info, I’ll check the retaining but when I replace the clutch in the not to distant future. Won’t worry about it...
@ruckusman it’ll be a lot of work to remove the engine and check them though, what are some tell tail signs of valve clearances being out of spec?
I just watched a YouTube video of a guy with the same issue on a Suzuki sv350 and was the basket retaining bolt which wasn’t correctly torqued....
What does the valve clearance cost at a mechanic and generally speaking at what mileage will they need doing? Signs of clearances needing...
Yet more questions follow though :offtopic: To all the fzr owners out there; how noisey is your clutch? Specifically during idle and only with the...
@GreyImport I had a quick look at the EXUP cables on the servo side only - they were super loose! Tightened them up without going through the full...
@GreyImport haven’t touched the EXUP yet, I’ll have a read through and see how it looks. Thanks
What about just connecting a tacho onto the #1 ignition lead and negative on the coil pack(one which is designed for this) Or is it possible to...
To be fair though without the air box on it won’t rev properly, perhaps on another bike he’s experienced it. Anyway, so pleased to say it’s...