Separate names with a comma.
So I sold the fzr...but for good reason, the oak I bought it from also has a cbr250rr, and I'm keen on buying, anything specific to look out for...
@maelstrom Yes I agree with you I just didn’t expect it to run this badly
Ok so I took my first ride today, and the bike is running very rough, what I did is I adjusted the float levels with that 16mm card cut out...
[MEDIA] She is alive!!..And with it brought a bunch of new problems:headbang:....I had the throttle cranked full just to keep it idling, as soon...
@ruckusman I wil take those measurements on the valves today and get back to you. Also yes that is a paper gasket, I made it myself because I did...
@ruckusman Thanx for that info, i’m 100% sure now it is a 2 kr motor, but with a 3ln1 head because of the screw holes for the radiator brackets,...
Well thats intresting..I guess they put 2kr rods on it as well because its not hitting the head,but is the rods compatible with the crank? what...
Ok so I read this too late head is off, block is off and I got to the pistons, those rings are stuck pretty good and it takes some force to get...
I’ve got good news and Kak news, good news, I found the problem, put some oil in the combustion chamber, compression felt loads better, cranked...
So I managed to machine down some shims to get clearance, all cylinders have clearance now but I didn’t check the exact clearances, just stuck a...
My attempt at machining down the shims was a fail:(, the first one I faced worked beautifully, then when I wanted to turn the second one it...
Like I said only thing keeping me from getting a shim kit is the lock down, So my plan of action is as follows, im have a very small lathe that...
Just for interest sake, what is the lowest value you can shim the fzr clearances? My values does seem a bit low and i'm starting to consider...
I know my local bike shop will have shims, so getting them isn't a problem, and ordering online wont help because of the lockdown, looks like i'll...
So we checked the clearance, and only 6 of 16 have clearance, the rest are open, so thats a bummer, dont know where I can get shims with the...
Ok so we ‘primed’ the cams before swinging the bike and the rubber caps popped of on all cams so we have oil pressure.. now that everything is...
So I reconditioned my head and just finished putting the top back on the bike, and as I was swinging the bike by hand as is good practice, I...
Anyone know where to get a sticker kit for this specific colour scheme?
So I took off the head and the sleeves, and the oil ways looked gummed up with rtv, they tried to make a base gasket and also smeared it with rtv,...
Ok so I checked the timing and its spot on, I then decided to remove tension on the bearing caps and the motor freed up, I traced the problem to...