Separate names with a comma.
Hi everyone, sorry to resurrect an old thread but im in need of some help regarding the running of my bike following completion of new engine...
Engine only has a small amount of damage to the piston in the one cylinder where the one valve broke. Local machine shops say they’d struggle to...
Hi there everyone. For the sake of some closure and just to say thanks again for everyones great suggestions I thought I'd let you guys know what...
Yea im thinking so too, hopefully that can give me a definite answer. Thanks everyone for all the help and suggestions. Once lockdown is over ill...
right so i pulled of the exhaust and had a look at the exhaust valves, all are in place no wiggling or anything, is there something else i should...
would the leaky air boots actually have a chance at causing it to run as poorly as it does? also if it was lean wouldnt the plugs be coming out...
Yea im thinking compression test or inspection camera down the plug hole. Just seems weird that something to cause the cylinder to have no/low...
When i had the carbs off stripped cleaned a rebuilt i checked all the diaphragms and they were in good condition no splits, and replaced those...
alrighty bike is back together and running, nothing has made a difference, i have been running it with no airbox and have just noticed that carby...
found @GreyImport 's article on testing the coils, primary windings of both coils test as 3.2ohms and cylinder 1,4 secondary was 15k and cylinder...
@jmw76 checked all plugs in the bike with multimeter set to ohms and all plugs report as open circuit, old plugs that came out all test at ~5k...
@jmw76 yes i checked the plugs before i put them in and all were the exact same reading on the multimeter, is there any way of testing the...
yea spark at every cylinder, all cylinders are running. have replaced all the spark plugs and have rethreaded the caps on the leads also
Is there a certain spec for how far the pickup needs to be from the flywheel or stator? if so would i find that in the owners supplement?
Right I have come back bearing news, news which im unsure what to do with. @GreyImport i pulled the cam cover off and the chain is perfectly...
Yes when i first purchased the bike i went through and made sure the exup was all working correctly and cables were adjusted, you can hear and see...
@Linkin thanks for the reply, a lot of the rattly noise from the engine seems to come from the clutch, it goes away when you pull the lever in. Is...
When i cleaned the carbs i took them right apart, cleaned everything set the mixture screws back to standard and it made no difference to how it...
I haven't done them or had them done, no. Bike had been running fine for around 1200km from when I bought it till now if that makes any difference
Okay so I did that and the headers all seem to get hot and feel like roughly the same heat coming off them?