Separate names with a comma.
New embroidery workshop door arrived today - don't know how but a bike found its way in there. [IMG]
Work has slowed to a snails pace - I had arranged a few months off work to get on with building her embroidery shop, house reno's and a bit of...
Well that is a load of s##t. Over the past few years I've repaired a few bikes that had minimal damage but were economic wright-offs. The damage...
My bad....sorry I was mistaken.
For my GT250B rebuild replacement fork tubes weren't available hence using RAD for the rechrome. For the GT250L rebuild TnK had new tubes listed....
Last set I sent to RAD was $420 - rechrome (badly pitted on upper part) and straighten. Did a fantastic job!
Distinguished Gentleman's Ride 2021 Perhaps not the best choice of bikes due to the stop/start nature of the ride (high gearing, no power under...
And if you were in the ride I am sure you suffered in the blue smoke (might need to turn back the oil).
Lathe Gremlins. Needed to make a few bearing drifts for the engine strip - The DRO on my lathe failed a week ago, whilst annoying wasn't a show...
If I have to I will go down that road - so far I have always found bearings. I am sure the supply will eventually dry up.
Engine strip. Cracked open the cases - I suspect failed crank seals after fuel sitting in the crankcase from leaking past the needle and seat (no...
How about taking off the anorak and just enjoy it for what it is!
I spent a few hours in the QLD Transport office trying to register the TR250. As it is Pre-ADR (Australian Design Rules) there is no compliance...
Not so much for my bike but for a friend with a Suzuki GS750 sidecar who wanted a new patch for his carpet. Helped myself to the Mrs new...
I want my bike bench back for the 74L resto, so the last job on the TR250 that I need it up there for is the oil system. The bloke who built the...
The positive side to spending so long away is three months worth of parts scrounging and packages to open - just like Christmas! [IMG]
New loom..........Had all the correct colour/trace wires in stock so it will even match the factory wiring. Pegged the old loom against a piece...
No sorry mate - had a couple of phones since then!
https://www.gumtree.com.au/s-ad/lithgow/motorcycles/1980-suzuki-gt250-h7/1272028815
Carbies. Went through my collection of broken and bent carbies and have managed to salvage a decent set. There are still a few parts on order...