Separate names with a comma.
It could be worse,,,[ATTACH]
Groundhog day returned, and passed, again,,,
2011 this build begun, 2013 was it's first run,
Iv'e been hacked, said the Guzzi V50 frame to it's new resident in waiting (I need to redo the intake manifolds using custom 85 degree mandrel...
"Helped me get to just over 180kph with 5,000 rpm left on a very bumpy bit of salt."
Last time I went down the salt, speedo readings didn't count...
Chinese copies :oops:
Room. or the lack of it, to cross the runners, they would need to be "squashed"
Cosy carby trial & starter motor drive thought day today, It feels good to progress into new territory for a change ;)
As we move into a new month, I'm pleased to see the end of July, which, for me, was a groundhog month, due to discovering the main bearing shells...
Unfortunately, during the trial assembly, a 1/4 drive 12mm socket went into the bowels of the engine, it was found resting under a piston,...
The morning started with 13 degrees, overnight rain to settle the dust, and a visit from the postman
one way Damnit
I wired everything thru a relay, & fed the power to that via a tether, cut the power to the relay, everything dies.
The postman scared me with a 30 Quid shipping quote for 75 Quid's worth of main bearing shells, but what can ya do , but cough up :commando:
You aren't the Lone Ranger there Mate,,,,,,
I was itching to start mounting the carbies, and associated linkages, but revisiting forward...
I've been chasing the reason one crankshaft seems awfully tight to get turning, the way I went about it was to oil up the engine while spinning...
I'd rather destroy a few sets of China's best while finding that elusive "tune"
There's 2 ways of reducing your C/R Akeizm, you could try this...
Hangin' with the big boys
It all started with a postie bike, and ended with just a postie bike kick start lever..
The bottom end is an early 70's Honda...
No worries,,that 'rod was a 1 off, (fzr600 + 3mm length) for this