Separate names with a comma.
It was the YEIS I was thinking of, but both do similar jobs.
I thought the YICS was just an extra chamber in the induction system to help with torque.
Bit of a sad state, but might be an interesting bike for someone. Unusual tail piece.
Welcome David. I am also in the process of restoring a 1985 VT250F2 and have found a lot of parts on Aliexpress (engine bearings, cables, rubbers,...
That one is for a Spada.
For VT250F you need 17210-KE8-000
Yes, my mistake should cover radiator. The fact I couldn't see and screw holes made me think it was complete.
No fairings missing, but does have wrong front guard. In better condition than mine when I bought it. See full story here....
Welcome. Bike looks to be in good condition (if a little sun faded on some parts) so enjoy.
I left the swingarm bushes in mine, just a large washer each side with a bolt/nut to hold them in.
Never seen a piece like that in an SL pipe.
Went to local gun shop and bought a .17 caliber brass brush to clean the female parts of wiring connectors. Chucked in battery drill on slow and...
Plenty of experience here so don't be afraid to ask.
I've not used a red,white and blue kit but if the instructions are followed to the letter/minute then it should work fine.
Could be fuel starvation from a blocked filter in tank or line to carbs. Ok at slower speeds but when on highway and needing more fuel it cannot...
Ooooh duckie, any rubber with a hole in it will do. :p
How many you want?
That frame would be perfect for a bobber/chopper/cafe bike builder, they are going to cut them up anyway. :lolsign: