Help I might have the wrong pressure switch installed

Sorry there was the same post back in 2013 but it was confusing me with how the bike initially sets up to start.

when I put the dash back in I found the oil light was missing. After replacing, when I turn the key on the oil light comes on. Turn the run switch to on and the oil light go's out. Start the bike and the oil light comes on and stays on.

*The pressure switch/oil level switch has continuity when the bike isn't running and is open circuit when the bike is running. So it doesn't matter if I disconnect the wire on the switch as the switch is open circuit when running. Plus I took it off and the light stays on

* checked the run switch and all looks clean inside

* Changed the oil and filter

* Oil level is on the top of the sight glass when the bike is upright

* If I earth out the wire on the switch when the bike is running the the oil light go's out

My question is dose your oil light come or off when you turn on the run switch

 

If someone could also check if there pressure switch has continuity when the bike is running or off. That would be very helpful thankyou

 

Thanks @GreyImport for information. I have the later model pressure switch with the screw on oil filter

 

I ordered the only pressure switch i could find which was in France and as it turns out I did have the wrong pressure switch installed. ali working good now