Hey guys I'm currently rebuild my engine and have pretty much finished everything but finding a problem when installing the cams. I've lined the T Mark to the notch in the bottom end but when I go to install my cams they sit 2mm out from being completely aligned. In the images you will see. I rotated the engine like this and the valves did not touch on the piston. Iv tried both positions described in the workshop manual but still end up in the same spot. Maybe this is normal but doesn't feel right.
Yeah iv tried adjusting both cams but it just won't line up. It seems to be out by half a tooth if that's possible?
i had the same problem on mine, seemed to be out by fanny hair, i just left it and turned the motor over afew times and it didnt change so i just put it all back together.
yeah it was all the same as before. you can take the cam holder off and do it again eventually it will line up perfect.