Pinned So what have you done to your bike today?

Discussion in 'The Pub' started by kiffsta, Nov 3, 2013.

  1. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    Also ebay offers heaps of mounts.. but you could always make your own..
     
  2. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed

    This is with the sealed case..
     
  3. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    I was using the waterproof backplate, because I'm too dumb to figure out how to change the backplates. I need a pin or something.

    Will be looking at getting an external mount, or fitting the go pro inside the helmet if possible
     
  4. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    if you have a look at the housing.. its a C shape.. so the steel bar just snaps into it...
     
  5. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    Right you are, just swapped it out.
     
  6. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    Had to go over the anzac and back today. I tried a new mounting position (underside of the windshield) with the skeleton back door. The camera is in upside down mode.

     
  7. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    Is it legal to lane split in N.S.W? cause if not... I personally wouldn't post anything about it.... Just my opinion is all..
     
  8. U_B_WARE

    U_B_WARE Well-Known Member

    Messages:
    322
    Likes Received:
    206
    Trophy Points:
    273
    Location:
    Redcliffe, QLD
    took the passenger pegs off the bike to get ready for single seat rego
     
  9. U_B_WARE

    U_B_WARE Well-Known Member

    Messages:
    322
    Likes Received:
    206
    Trophy Points:
    273
    Location:
    Redcliffe, QLD
    • Like Like x 1
  10. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
  11. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    Regardless of if it's legal or not (it is in NSW, under certain conditions), L & P platers aren't supposed to do it, which is very short sighted. Going from L to P to unrestricted doesn't magically make you able to filter like a boss. It has to be practiced because you can very easily smash mirrors.

    I would rather be pulled over and fined and waste time in court, than be rear ended and squished between 2 cars because a driver was texting...
     
  12. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    All I'm saying is to edit that part out because it can (not saying it will) bring some heat on you..
     
  13. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    It's not like I have a huge following on youtube...
     
    • Like Like x 1
  14. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    I hear you there.. As i said just my personal view....
     
  15. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    Moving on from the filtering thing... the audio is definitely better in that spot. Video is OK, could be better if the screen was clear and not all scratched up, but oh well...

    Also a shame that youtube doesn't fully support 60fps yet. Anything I upload will be 60fps, but you need html5 for it to work... otherwise you get 30fps, and I may as well record in 1080p
     
  16. Tim_

    Tim_ resident nutcase Contributing Member Dirty Wheel Club

    Messages:
    1,337
    Likes Received:
    662
    Trophy Points:
    543
    Location:
    In your bike shed
    so you have the hero3 black?
     
  17. Murdo

    Murdo The Good Doctor Staff Member Contributing Member Ride and Events Crew

    Messages:
    6,407
    Likes Received:
    4,795
    Trophy Points:
    1,148
    Location:
    Tamworth, NSW
    Made and fitted new gasket to my YDS-5, no more oil leaks (should have done that in the first place).
    Fitted plug and jumper leads to my 650.
     
  18. Linkin

    Linkin The Mechanic Premium Member Contributing Member Dirty Wheel Club

    Messages:
    4,741
    Likes Received:
    2,886
    Trophy Points:
    943
    Location:
    Sydney NSW
    No its a hero 3 white. Which can do 720p 60fps. The black edition can do all sorts of crazy resolutions (4k at 15fps, 2.7k at 30fps, 1080p at 60fps, 720p at 120fps and so on)
     
  19. TechHeadFred

    TechHeadFred Well-Known Member

    Messages:
    1,180
    Likes Received:
    734
    Trophy Points:
    498
    Location:
    Canberra, ACT
    Fitted the missing air filter and screws to Nix' airbox and put on the luggage hooks. Found out she's missing a hex drive frame bolt on the right side, will have to pick one up on Monday. :(
     
  20. Buzz22

    Buzz22 Well-Known Member

    Messages:
    37
    Likes Received:
    81
    Trophy Points:
    203
    Location:
    Sydney
    Took advantage of the beautiful weather and rode over to visit my gorgeous new niece Annabelle (born on friday).
    The ride over was a great head clearer and as a bonus I got to test my new Rjays seat bag- it's an absolute winner.
     
    • Like Like x 3

Share This Page