I've just noticed these cut outs on the sides of the tail section. I'm thinking about putting a set of indicators in them to make the rear end look similar to the ZZR400/600. Doing this will hopefully clean up the rear end, and slightly reduce drag.
The holes for the light mountings are inside the bodywork. Have seen the lenses for sale in Japan and China.
The inbuilt ones didn’t meet the Australian design rules , hence the bolt ons. I like the streamlined look
Vic road's say's rear indicator's must not be less than 300mm apart, don't know if that will be a problem? https://www.vicroads.vic.gov.au/-/m...x?la=en&hash=81953AD6CC58BF5F2A8F3A22999D1445
Just did some research about the legal minimum width, and what I read says that I should be fine just so long as the inner edges are at least 180mm apart