Project Suzuki Across

Discussion in 'Your 250cc Projects' started by Tonino, Mar 13, 2021.

  1. Tonino

    Tonino Active Member

    Messages:
    36
    Likes Received:
    8
    Trophy Points:
    178
    Location:
    Melbourne
    I just got hold of a pretty ratty 250 Across which runs but has compression issues in that i cylinder has ZERO compression and one very low.
    I need to take the head off to see whats what and would like to do it without removing the engine. Is it possible?
    Also are all the parts like rings and valves etc etc available for am Across?
    Where can I find a Workshop Manual?
     
    Tonino, Mar 13, 2021
    #1
  2. GreyImport

    GreyImport Administrator Staff Member The Chief Contributing Member

    Messages:
    10,931
    Likes Received:
    6,723
    Trophy Points:
    1,168
    Location:
    North by NW NSW Oztralia - Tamworth
    • Like Like x 1
    GreyImport, Mar 13, 2021
    #2
  3. Murdo

    Murdo The Good Doctor Staff Member Contributing Member Ride and Events Crew

    Messages:
    6,406
    Likes Received:
    4,793
    Trophy Points:
    1,148
    Location:
    Tamworth, NSW
    • Like Like x 1
    Murdo, Mar 13, 2021
    #3
  4. Tonino

    Tonino Active Member

    Messages:
    36
    Likes Received:
    8
    Trophy Points:
    178
    Location:
    Melbourne
    Thanks a million. Any idea where to find a head gasket?
    Not sure if I need a piston yet but there is ZERO compression on one cylinder but yet to open the motor.
    But will definitely need a gasket
     
    Tonino, Mar 15, 2021
    #4
  5. Murdo

    Murdo The Good Doctor Staff Member Contributing Member Ride and Events Crew

    Messages:
    6,406
    Likes Received:
    4,793
    Trophy Points:
    1,148
    Location:
    Tamworth, NSW
    Suggest going to someone like Mick Hone Motorcycles and getting a genuine gasket.
     
    Murdo, Mar 15, 2021
    #5

Share This Page