Spark Plugs

Discussion in 'Maintenance' started by kiffsta, Jan 6, 2011.

  1. kiffsta

    kiffsta Senior Member

    Messages:
    9,066
    Likes Received:
    6,872
    Trophy Points:
    1,168
    Location:
    Brisbane
    I friend of mine e-mailed me this plug guide as I have a project bike in the garage that wont start without a spray of Start Ya Bastard, so  I thought I'd share with you guys...

    Plugs

    Types
    There are hundreds of types, sizes and brands of spark plugs on the market, even so only a handful will work in your engine.
    As a general rule of thumb, use the plug as referenced in your bikes manual, (same brand and part number). 

    Reading a spark plug correctly:  There are two different main ways to read a spark plug. The first way is to just unscrew it out of the engine and take a look at the end of it, matching the chart below.. The second way is the same as  except you go for a really hard high revving ride on the bike, pull over and then unscrew each plug to read them. (Just make sure you wear gloves as they will be very hot).
    A spark plug can easily and quickly tell you the condition of an engine (good or poor), how it is running ie normal, rich or lean.

    CARBON DEPOSITS

    Symptoms: Dry sooty deposits indicate a rich mixture or weak ignition. Causes misfiring, hard shifting and hesitation.
    Recommendations: Check for a clogged air element, high float level, sticky choke and worn ignition points. Use a spark plug with a longer core nose for greater anti-fouling protection.

    OIL DEPOSITS
    Symptoms: Oily coating caused by poor oil control. Oil is leaking past worn valve guides or piston rings into the combustion chamber. Causes hard starting, misfiring and hesitation.
    Recommendations: Correct the mechanical condition with necessary repairs and install new plugs.

    TOO HOT
    Symptoms: Blistered, white insulator, eroded electrode and absence of deposits. Results in shortened plug life.
    Recommendations: Check for the correct plug heat range, over-advanced ignition timing, lean fuel mixture, intake manifold vacuum leaks and sticking valves. Check the coolant level and make sure the radiator is not clogged.

    PREIGNITION
    Symptoms: Melted electrodes. Insulators are white, but may be dirty due to misfiring of flying debris in the combustion chamber. Warning
     

    Attached Files:

  2. Phil

    Phil Senior Member Contributing Member

    Messages:
    3,613
    Likes Received:
    1,549
    Trophy Points:
    923
    Location:
    Sunshine Coast Qld
    Thanks Chris, great chart for plugs and information is fabulous. Plugs tend to get a hammering and putting new ones in is essential to keep the bike running at it's peak. Your chart however is a great diagnostic tool, it tells us whats going wrong, I like it   
    Cheers  Phil
     

Share This Page