Separate names with a comma.
All good, picked up a TZR one that will work.
Saw these online the other day. The full cowl doesn't really do it for me, but the tail section looks neat. Expensive compared to OEM reproduction...
Reminds me of those wack Tron paintjobs with reflective vinyl around all the panel seams.
Nice to see another Kiwi on here. What bike shop do you work at?
Despite my lack of activity on here, the project hasn't stalled! Clutch back together, with a new ball (old one was well and truly welded on),...
@Moo Still got that rear caliper? Happy to pay extra for shipping. Already got a rebuild kit.
Often abrasive crap will get stuck in the softer surface and wear the harder one. If it's only minor you could try lapping the seats in with...
A hundredth is well within margin of error. Wouldn't worry about it unless it's noisy.
The plates and springs actually look okay. Got some proper clutch bolts. The ball is easy enough. Just trying to find the adjuster. I'll smash the...
The clutch felt okay when the bike was off, but when it was running, it would stick open, requiring a tap on the pushrod camshaft to get the lever...
Yeah I snapped them up before I'd even opened up my carbs. Try looking for Suzuki part #13507-32C00. It's the same diaphragm that the 3LN uses....
Got a set of four, new and genuine from Colemans Suzuki. $160 for the lot. Found them on TradeMe. I reckon they just had the four and were trying...
Cheers guys. Already done the carb rebuild. Full set of seals from Litetek, new diaphragms. New stainless screws for good measure. New OEM fuel...
A testament to the quality of Japanese exhausts. Flange came off when I took the pipes off to do the filter. Looks like someone already tried...
Ran fine for 30 seconds or so, then started pissing oil/fuel out the case breather. Figured it had flooded itself (had been sitting for months...
Picked her up cheap last year. Reg on hold. Looked tidy enough, turned over after a charge. PO says 'just has a bit of a fuel leak'. Yeah...
Bit of TradeMe for the Kiwis. 3LN-3 wreck. Will probably go cheap. http://www.trademe.co.nz/motors/motorbikes/motorbikes/other/auction-1000380856.htm
Pushrod straight? Ball bearing still on the end? Edit: Go for a leak and I'm beaten to the punch.
Silicone works well. Convenient in a rattle can too. If the plasticizer has all flashed off, and the rubber has gone hard, try Rubber Renue, or...
Seen some China piston kits on eBay. Presumably from the same source as yours. Tempting for the money. Did you measure them? Same as standard? The...