Separate names with a comma.
Yeah I just figured may as well, whilst I'm there. These bits looked way nicer than what I put in their originally. I'll just swap back in the...
Thanks for your guidance everyone. That seemed to make a massive difference. In terms of idling no longer randomly dying that kit made a huge...
Legend thanks mate
Anyone aware of the output shaft/front sprocket nut thread dimensions? I'm missing this nut and don't have anything handy to be able to determine...
Thanks guys, I've purchased one of those carb kits with the brass piece, jet holder and jet needles. So I'll fit them for now, then balance carbs...
Yeah ok, I live in North Sydney. I'm half tempted to buy that kit that you've listed above, I got a dodgy one off eBay, which had jets, O-rings...
If anyone has a working carb, or one that would just need a clean out/new jets and hasn't been messed with too much, they'd be willing to sell let...
Hey guys, Still having dramas with the zxr250 fueling. Bike runs and rides ok now but is unpredictable sometimes cuts out, and rpms seem to jump...
Slicks would be nice when riding it around on track days, but eventually my plan is to run it in P6 Series so won't be able to use them then. But...
Was just doing some browsing across the forums, found a few guys using FZR250s (3LN) on track. A lot of those posts were quiet old, so I thought...
Thanks for all your help as well. Appreciate it, as that prior issue was making me go crazy.
Seems like I've solved my issue. All the tubes going out of the valve were blanked, so I assume that having it connected was just forcing air...
Hey Guys, Just an update. So I've gone ahead and replaced float needles and seats. Confirmed that the float height is correct. Initially all...
Thanks for your help guys, I had put new O-rings in when I went through the carbs. I think the issue most likely lies in the fact that my...
G'day guys, I'll preface by saying I have little experience with carbys. So I am more than likely making a simple mistake, or missing something...